Hach FL900 Series, Руководство пользователя, Страница: 20 / 30

Add the logger to the FSDATA Server
Pre-requisite: Serial number of the logger
Figure 11 Serial number location
N O T I C E
Be sure to enter the serial number and SVC correctly to prevent communication failure.
1. Go to the website http://fsdata.hach.com to access the FSDATA server.
2. Enter the user name and password:
• User name—the default user name is the 8-digit customer ID number
• Password—the default password is HachWebData
3. Go to Instruments > Instrument Manager .
4. Record the SVC (Server Verification Code) from the upper left corner of the screen:
_______________________
5. Click ADD NEW . The Add Instrument window opens.
6. Enter the serial number (SN) of the logger ( Figure 11 ).
7. Select the Instrument Type.
8. Select the Active check box and click OK . The instrument is shown in the Instrument Manager.
Configure the logger for remote communication
Pre-requisites: The logger must be attached to the computer. An account with a network provider
must be set up, and the server must be configured.
The settings for remote communication must be entered into FSDATA Desktop and then written to
the logger.
1. Start a communication session with the logger:
a. Open FSDATA Desktop.
b. Click CONNECT . The Connect to Instrument window opens.
c. Click the FL900 button.
d. Select the port on the computer where the logger is attached (serial or USB), then click
Connect .
Note: If the sensor mismatch message is shown, select "Create new program based on sensors
connected."
e. Make sure that the connection status shows "connected".
2. Go to the Communications tab. Enter the information for the desired site. Select Time Zone.
3. Complete the Remote Settings information:
Option Description
Verizon 4G No additional configuration is necessary.
18 English