I. THE USE OF HEATERS
The device is used to heat basalt massage stones.
II. CONSTRUCTION OF HEATERS
Model 6l
Model 17l
cover
water tank
temperature controller
heater
control lamp
III. SAFETY RULES FOR USE OF HEATERS
1. Do not pour water into the heater.
2. Do not touch hot surfaces.
3. Do not throw the cord, plug or heater into water or other liquids.
4. Before disconnecting the device from the power supply, turn off the device.
5. Do not use the device while bathing.
6. Be careful when children are near the operating device.
7. Disconnect the device from the power supply when not in use or when cleaning is done.
8. Allow the device to cool down before removing any parts or cleaning them.
9. It is not allowed to use the device with a damaged cord or plug.
10. Modifications to the device may result in fire or electrocution.
11. The device should be used indoors.
12. The power cord should not hang over the table or touch hot surfaces.
13. Do not put the device on gas burners, electric heaters or ovens.
14. Be careful by moving the heater with hot water inside.
15. The device may only be used for the applications described in this manual.
16. The water tank of the heater may be filled up to maximum of 2.5 cm below the top edge.
17. Always put stones in the tank first and then pour water.
18. It is forbidden to scoop water using the device when it is connected to the power.
19. Check the temperature of stone with your fingers and then hold the stone in your hand before
placing it on the patient.
20. To avoid burn, use a special glove or spoon to take out stones from the heater.
21. To avoid burn, do not fill the device with boiling or steaming water.
7
EN
