Black/Blue - Neutral
Red/Brown - Live
Ensure electrical connections are tight and no loose strands of wire are left out of the terminal block.
If in any doubt about the type of wiring you have available or the location of
your mirror please consult a qualified electrician.
This fitting is IP44 rated therefore suitable for installation in bathrooms as defined by the I.E.E.
Wiring Regulations. IP44 fittings are splashproof, suitable for Zones 1 & 2 except where likely to come in to direct
contact with water jets. An example of exceptions would be in a shower cubical or an area where water jets are
used for cleaning purposes.
It is recommended all bathroom appliances be protected by a 30mA RCD Circuit Breaker.
Please use the Guide below to ensure the correct positioning of your luminaire.
ZONE 2
60cm radius
from tap
ZONE 0
225cm
ZONE 1
ZONE 2
60cm
240cm
Important: Ensure the house electricity supply is off at the fuse board. Ensure other
persons cannot restore the electricity supply without your knowledge.
Before removing the existing fitting, carefully note the position of each set of cables. If
there are loops in cables that are not connected to the light, these must be terminated in a
separate terminal block not connected to the fitting.
Instruction to use
.
wall
