habitat et jardin Luzern 727, Руководство пользователя

Страница: 8 / 12

Now check again that the whole structure is perfectly square, that the doors can be opened and closed properly
and that the gable follows the lines of the front and back wall- if all this is all right, work can commence on the
roof.
followed by the to form a firm surface (not too tight),
All the profiled boards should be nailed securely to the
walls, gables and purlins - please trim the last boards (for example, using a fretsaw) for a flush edging on the
outer rim of the purlin/roof edge.
The roof boards have slightly rounded corners in the front side and chamfers and one groove in the back
side. They are assembled the rounded side downwards and the side with the chamfers and the groove upwards.
Attach the fascia boards C4 flush with the roof - . Then the work can begin on the roofing shingles.
Here again, any unevenness caused by the planer, rough edges etc. even in the grooves and tongues, are
due to well-tried production techniques and quite normal and not a reason for reclamation.
Begin with the 2 profiled boards, with the groove pointing outwards, on the outer edge of the purlins/the
top edge of the roof C3;
other profiled boards,
diagram 5. The entire roof should be checked for parallel eaves, a uniform overhang over the walls and
an even, firm support in the case of the purlins.
A firm, durable anchoring of the roof is important for the stability of the
cabin as a whole!
Take care when you work! The roof is not intended for standing on!
diagram 6
Important! After nailing the roof boards they must be covered immediately!
Roofing
6.
C4
A6/B3
A7/B4
Start
Finish
Sawing
direction
8
Luzern 271205