User Guide
TGT. 12.03.2019
Technical
Page 12 of 21
©Copyright by Habegger Maschinenfabrik AG
Version 03 / 12.03.2019
Load
The load is attached to the traction hook using the appropriate means of fastening. This prevents the load from slipping or
tipping during operation.
Appropriate means of fastening are, e.g., eyelets, loops, straps, harnesses.
The load’s inherent stability must be guaranteed in order to prevent any slipping or tipping during operation.
Be aware of obstacles which would cause the load to tip or jam.
Refrain from using unchecked loads (e.g. buckets, containers) during the operating stroke or in intermediate positions or
monitor them with a load-weighing device.
Please take possible stress peaks (in static positions) from external influences into consideration during periods of resting
during operation and anchoring work.
Excessive blows to and stresses on the rope pulling machine (e.g. anchoring to machines which have been moved, wind, etc.)
should be prevented by use of a strain release wire.
-
Danger! Do not store load, pulleys and cables in the danger zone!
-
Secure freely suspended loads against twisting!
Pulling, hoisting and lowering
Check that you have the correct direction of rotation for hoisting and lowering before commencing operation. If the direction
of rotation is incorrect, consult an electrician to check the direction of rotation of the phases and, if required, to correct them
(check any extension cables which may be present). (See chapter 2).
The careful installation of the cable drive and the machine assembly is the best guarantee of smooth operation.
Place the cable on the rocker as shown on the information sheet (see chapter 5.2, observing the location of the cable with
the load hook)
Check the length of cable and the machine’s hoisting abilities by pulling!
Observe the movement of the load!
In the event of being pulled diagonally, the rope pulling machine can tip over. Place wood underneath or avoid diagonal pull
using a pulley.
If anything is unclear, request supervision from an assistant, via radio communication if required.
-
Close and secure the housing cover over the driving system using screws before operation. This way the
cable is protected against derailment and no foreign objects can enter.
The free end of the cable must also be able to exit the rope pulling machine unhindered.
-
Never allow the hook to touch the housing.
When lowering, ensure that the rope is long enough. Stop at least 2 m before the end of the cable and place the load under-
neath or rehang it.
