Haas TL-1, Руководство оператора

Страница: 6 / 22

4
96-0112 Rev W
July 2010
2. Run Z-axis left to right and level machine by adjusting leveling screws. Verify
each leveling screw requires approximately same torque to turn for proper load-
ing. Once completed, tighten lock nuts on leveling screws.
3. Re-position cross-slide close to chuck, and place the level on the cross-slide,
parallel to the Z-axis and run Z-axis left to right and level machine by adjusting
leveling screws. Verify each leveling screw requires approximately same torque
to turn to ensure proper loading. Once completed, tighten lock nuts on leveling
screws.
tl-4 l
eveling
Place the lathe in position on the shop floor. Rough level by measuring from the
floor to the bottom of the base (very close to 3.5 inches). Do this to the 4 corner
leveling screws. The 4 middle leveling screws must not touch the leveling pads.
Loosely screw the jam nuts onto the leveling screws. An electronic level is
required for the installation. The leveling specification is +/- .00015”.
1. Loosen the front corner leveling screw (3) so that it is just above the leveling
pad and jog the cross-slide to the end of Z-axis travel closest to the spindle head
and to the middle of X-axis travel.
2. Position the level on the cross-slide, parallel to the X-axis and adjust the cor -
ner leveling screws closest to the spindle head (1,4) until machine is level.
3. Position the level parallel to the Z-axis. Adjust the corner rear leveling screw
closest to the tailstock (2) until machine is level. The front screw (3) was left
loose and must remain loose.
4. Position the level parallel to the X-axis. Jog the cross slide along the Z-axis
from the spindle head to the tailstock. Adjust the front corner leveling screw (3)
until machine is level.
5. Jog Z-axis through its travel range to verify there is no twist. Adjust corner
leveling screws until twist is removed.
6. Recheck the level in both X and Z-axes with the level parallel to the X-axis
and recheck the level in both X and Z-axes with the level parallel to the Z-axis.
7. Finish leveling procedure by adjusting the 4 leveling screws in the center of
the lathe until they are touching the leveling pads. Secure all leveling screws
with a jam nut. Verify lathe remains level (X and Z-axes).