12
Figure 14 Marking installation hole locations on the wall
2.
Drill holes with a diameter of 8 mm (0.32 in) at the marked locations, as shown in
.
When you drill holes, follow these restrictions and guidelines:
{
Hold the drill handle with both hands, with the bit vertical to the wall surface, and prevent
wall damage or tilted holes.
{
If the wall surface is too solid and slippery to locate the bit, punch a notch first.
{
Each hole must have the same depth.
3.
Hammer expansion bolts into the holes and remove the nut and washers from each bolt. Do not
hammer the expansion bolts all the way into the wall and leave some space for hanging the AP.
Figure 15 Installing expansion bolts
4.
Hang the AP on the expansion holes and fasten the screws to secure the wall/pole bracket to
the wall, as shown in
.
5.
Use an M6 screw to secure the articulating arm (attached to the AP) to the wall/pole bracket.
150 m
m (5.91
in)
