H3C WA2612-AGN, Инструкция по настройке через веб-интерфейс, Страница: 30 / 447

17
Click Next to enter the configuration summary page.
If you want to modify certain configurations, click Back to return to the previous pages; if the
configurations are correct, click finish to apply the configurations.
Verifying the configuration
• Launch the wireless client, and refresh the network list. Select the configured service in Choose a
wireless network ( wep in this example), and click Connect . In the dialog box that appears, enter
the WEP key 12345 (same as the WEP key configured on the AP). The client can access the WLAN
network after being associated with the AP.
•
You can view the online clients on the page you enter by selecting Summary > Client from the
navigation tree.
WPA2-PSK authentication configuration example
Network requirements
In a small office as shown in Figure 18 , perform WPA2-PSK wireless access configuration on the AP. The
following requirements must be satisfied:
• The AP provides a WPA2-PSK wireless access service with SSID psk .
•
802.11n (2.4 GHz) is adopted to inter-work with the existing 802.11g network and meet the high
bandwidth requirement.
Figure 18 Network diagram
Configuration procedure
1. Performing basic configurations:
From the navigation tree, select Quick Start to enter the home page of the Quick Start wizard. Configure
time parameters, login password, and login IP address as needed.
2. Configuring wireless service:
a. On the IP configuration page, click Next to enter the wireless configuration page, as shown
in Figure 19 .
b. To configure wireless service:
Use default setting for Primary Service Authentication type .
Specify the SSID as psk .
Select the Encrypt box.