H3C UniServer R6700 G3, Установка, Быстрый старт

Страница: 8 / 11

2
Installing the processor
CAUTION:
•
To prevent damage to the pins on the processor socket, always install a cover over an empty
processor socket.
•
Make sure all processors on a server are the same model.
•
To avoid damage to a processor, always hold the processor by the edges. Never touch the gold
contacts on the processor bottom.
IMPORTANT:
The server supports one, two, or four processors.
To install the processor:
1. Install the processor onto the retaining bracket.
a. As shown by callout 1 in Figure 1 , line up the small triangle on the processor with the
alignment triangle molded into the retaining bracket, and align the guide pin on the bracket
with the notch on the processor.
b. As shown by callout 2 in Figure 1 , lower the processor gently and make sure the guide pins
on the opposite side of the bracket fit snugly into notches on the processor.
Figure 1 Installing the processor onto the retaining bracket
2. Install the retaining bracket onto the heatsink.
CAUTION:
When you remove the protective cover from the heatsink, be careful not to touch the thermal
grease on the heatsink.
a. Remove the protective cover. As shown in Figure 2 , lift the cover straight up and away from
the heatsink.