H3C UniServer R2700 G3, Руководство пользователя

Страница: 133 / 226

7-50
Replacing the front I/O component (8SFF/10SFF server)
The 8SFF and 10SFF servers support the following types of front I/O components:
•
Independent front I/O component.
•
Front I/O component attached to the front media module.
The replacement procedure is the same for all types of front I/O components. This procedure uses
an independent front I/O component as an example.
Procedure
1.
Power off the server. For more information, see " Powering off the server ."
2.
Remove the server from the rack. For more information, see " Removing the server from a rack ."
3.
Remove the access panel. For more information, see " Removing the access panel ."
4.
Disconnect the front I/O component cable assembly from the system board, as shown in Figure
7-61 .
Figure 7-61 Disconnecting the front I/O component cable assembly
5.
Remove the screw that secures the front I/O module, and then pull the front I/O module out of
the slot, as shown in
Figure 7-62 .