H3C UniServer BX1010E, Руководство пользователя

Страница: 17 / 48

0
Configuring the switch module
Examples are used in this section for your better understanding.
Accessing the switch module
Obtaining required data
Before accessing the switch module, obtain required data as shown in Table 8 .
Table 8 Obtaining data
Parameter Setting
OM management IP
•
Management IP address (default): 192.168.100.100
•
Subnet mask (default): 255.255.255.0
OM username and password
•
Username (default): admin
•
Password (default): Password@_
Slot where the switch module
resides
1
Data in this table is used as an example.
Accessing the switch module from the SYS serial port
(console port)
Prerequisites
•
The switch module has been powered on. For information about powering on the switch module,
see "Powering on the module."
•
You have connected your PC to the SYS serial port (console port) on the switch module. For the
location of the console port, see "External ports."
Procedure
1. Open a remote access program and set the login parameters.
Table 9 Login parameters
Parameter Setting
Serial line to connect to
COM n . n is an integer and represents the console
port number.
Speed (baud) 9600 (default)
Data bits 8 (default)
Stop bits 1 (default)
Parity None (default)
Flow control None (default)
2. The following information is displayed after you access the CLI of the switch module.
********************************************************************************