H3C SR6616, Руководство по установке

Страница: 151 / 185

142
Table 66 1000BASE-X-SFP port specifications
Item Specification
Connector type LC
Transceiver module type SFP
Interface standards 802.3, 802.3u, and 802.3ab
Operating mode 1000 Mbps, full duplex
Table 67 10GBASE-R-SFP+ port specifications
Item Specification
Connector type LC
Transceiver module type SFP+
Interface standards 802.3ae
Operating mode 10 Gbps, full duplex
For the copper combo port specifications, see Table 65 .
For the fiber combo port specifications, see Table 66 .
Transceiver modules
For more information about transceiver modules supported by the SR6616 switch, see the
H3C
SR6600/SR6600-X Routers Interface Module Guide
.
Lightning protector for a port
Before connecting an outdoor Ethernet cable to an Ethernet port, you can install a lightning protector
to protect the router against lightning strikes. The specifications for the lightning protector that can be
installed on the router are as follows:
Port protective unit–single port, maximum discharge current (8/20 μ s waveform): 5 kA, output voltage
(10/700 μ s waveform): core-core < 40 V, core-ground < 600 V.
For how to install the lightning protector for a port, see " Installing a lightning protector for a network
port ."
Power strip with lightning protection
If part of the AC power line is routed outdoors, use a power strip with lightning protection to connect
the AC power cord of the router to the AC power line to protect the router from being damaged by
lightning strikes. You can attach the power strip to the rack, workbench, or wall of equipment room.
The specifications for the power lightning arrester that can be installed on the router are as follows:
Maximum discharge current: 6500 A, protection voltage: 500 VAC to 220 VAC.
For how to connect the AC power module to a power strip with lightning protection, see " Connecting
the AC power supply to a power strip with lightning protection ."