5
4.
Identify the aggregation mode of the aggregation group.
{
If the aggregation mode is static, go to step 6.
{
If the aggregation mode is dynamic, go to step 5.
5.
Verify that the peer member ports have the same attribute configuration and class-two
configuration as the peer port of the reference port:
a.
Execute the
display current-configuration interface
command on the peer
device to display the configuration of the peer member ports.
b.
Configure the peer member ports to make sure the peer ports have the same attribute
configuration and class-two configuration as the peer port of the reference port.
6.
Verify that the number of member ports in the aggregation group does not exceed eight. If the
limit is exceeded, remove undesired member ports from the aggregation group.
7.
If the issue persists, contact H3C Support.
Related commands
This section lists the commands that you might use for troubleshooting link aggregation.
Command
Description
display current-configuration
interface
Displays the running configuration of an interface.
display interface
Displays interface information.
display link-aggregation verbose
Displays detailed information about aggregation groups.
Troubleshooting ports
This section provides troubleshooting information for common port issues.
Port failure to come up
Symptom
When a port is connected to a peer port, the port cannot come up.
