8-13
Step3
Power up the V100-E and check state of the corresponding LED on the V100-E. ON means that the
module has succeeded in the POST and works normally. OFF means that the module fails the POST.
Contact your agent in the latter case.
Step4
Check the state of the LINK LED on the GEF module. ON means the Rx link is present and OFF means
no Rx link is present. Check the connection in the latter case.
HNDE Module
Introduction
High Network Data Encryption (HNDE) supports IPsec protocol, multiple hardware
encryption/de-encryption and hash algorithm to speed up the encryption of the IP packets, featuring
high-performance and high-reliability.
Insert HNDE module in the MIM slot of the SecPath Series Security Products. The main board forwards
the IP packets and implements the VPN with encryption feature which is complemented by encryption
card.
Interface Attributes
Table 8-9
Interface attributes of the HNDE module
Attribute
Description
Protocol supported
IPsec
Hardware algorithm
Key algorithm (DES, 3DES, AES)
Authentication algorithm (HMAC-MD5-96, HMAC-SHA-1-96)
Panel and Interface LEDs
Figure 8-19 shows the HNDE module panel.
Figure 8-19
HNDE module panel
Table 8-10
LEDs on the HNDE module
LED
Description
STATUS
ON (green): The HNDE module is powered on properly.
OFF: There is no power supply, damaged power supply, or sever hardware
failure.
ACTIVE
OFF after flashing yellow for two seconds: Initialized the HNDE module.
Blinking continuously: The HNDE module operates normally and there is data
transmission with the host.
OFF: HNDE module runs normally and no data transmission exists with the
host.
