H3C SecPath Series, Руководство по эксплуатации

Страница: 25 / 41

Operation Manual – User Access
H3C SecPath Series Security Products
Chapter 2 PPPoE Server Configuration
2-4
Table 2-5 Displaying and debugging PPPoE server
Operation Command
Display the status and statistics of
PPPoE sessions display pppoe-server session { all |
packet }
In the table, the parameter all indicates to display all information of each session ,
packet indicates to display packet statistics of each session .
2.4 PPPoE Configuration Example
I. Network requirements
In Figure 2-1 , the hosts access the Internet through the firewall SecPath by making use
of PPPoE.
II. Network diagram
Firewall SecPath is connected to the Ethernet through the interface Ethernet 1/0/0 and
the Internet through Serial3/0/0.
Internet
Host
Host
SecPath
Ethernet 1/0/0
Ethernet 3/0/0
Figure 2-1 PPPoE network diagram
III. Configuration procedure
# Add a PPPoE user.
[H3C] local-user NE
[H3C-luser-NE] password simple pwd
[H3C-luser-NE] service-type ppp
# Configure PPPoE parameters on the firewall.
[H3C] interface ethernet 1/0/0
[H3C-Ethernet1/0/0] pppoe-server bind virtual-template 1