19
Figure2-14 Removing the filler panel
2.
Pull the ejector levers on the module outward and slide the module slowly into the slot along the
guide rails.
3.
Press the ejector levers inward until they touch the panel tightly and the module seats into the
slot securely.
4.
Use a screwdriver to fasten the captive screws on the module.
Figure2-15 Installing an interface module
Installing a drive
CAUTION:
•
Drives are not hot swappable.
•
To avoid damage to drives, always hold a drive by its sides. Do not touch any components and do
not squeeze, vibrate, or strike a drive.
•
Install a filler panel in empty drive slots to prevent dust and ESD damage.
IMPORTANT:
•
The firewall does not come with any drives and cannot recognize drives from other vendors.
Purchase drives from H3C as needed.
•
Before using the drive, execute the
fdisk
and
format
commands from the CLI to partition and
format the drive.
To install a drive:
1.
Wear an ESD wrist strap and make sure it makes good skin contact and is reliably grounded.
2.
Remove the filler panel from the drive slot.
3.
Press the button on the drive panel to release the locking lever.
4.
Hold the locking lever and push the drive into the slot slowly along the guide rails. Then close
the locking lever.