Powering on the switch and verifying its operation
交换机上电并检查
Make sure the power cords are connected correctly and the power source is operating correctly. Then power on
the switch. Verify that the switch is operating correctly by observing the LEDs on the switch. For more information
about the LEDs, see
H3C S7500X Switch Series Installation Guide
.
确认电源线已经正确连接到外部供电系统且供电系统已正常供电，使设备上电。请您根据设备各部件的指示灯正常
状态来检查设备是否正常。关于设备指示灯状态的详细描述，请您参见《
H3C S7500X
系列交换机 安装指导》中的
“附录
C
产品指示灯介绍”。
7
USB console port
USB Console
接口
Console port
Console
接口
Connecting the power cord for a PSR1200-D power module
连接
PSR1200-D
电源线
Connecting the power cord for a PSR320-D/PSR650-D/PSR650C-12D power module
连接
PSR320-D/PSR650-D/PSR650C-12D
电源线
3
2
1
4
5
1
2
3
Connecting the power cord for a PSR1400-D/PSR1400-12D1/PSR2500-12D power module
连接
PSR1400-D/PSR1400-12D1/PSR2500-12D
电源线
To access the switch for the first time, use a console cable to connect the console port or USB console port
on the switch. If you connect both the console port and USB console port, only the USB console port is
available.
当您首次登录设备时，只能通过
Console
口
/
USB Console
口登录。如果
Console
口和
USB Console
口同时连
接电缆，仅
USB Console
口可以正常通信。
Connecting the console cable
配置电缆连接
Accessing the switch
1
2
3
5
6
4
Copyright © 2016-2021, New H3C Technologies Co., Ltd.
The information in this document is subject to change without notice.
Copyright © 2016-2021
新华三技术有限公司 版权所有，保留一切权利。
如需了解产品及安装方面的更多信息，请登录
H3C
网站
www.h3c.com
