2-31
The LSVM1AC650 and LSVM1DC650 installation procedure is the same on the S6850 and S9850
series switches. The figures in this section use the S6850-56HF switch as an example.
To install a power module:
1.
Wear an ESD wrist strap and make sure it makes good skin contact and is reliably grounded.
2.
Remove the filler panel, if any, from the target power module slot, as shown in
Figure2-51 Removing a filler panel
3.
Unpack the power module and verify that the power module model is correct.
4.
Correctly orient the power module with the words on the power module upward. Grasp the
handle of the power module with one hand and support its bottom with the other, and slide the
power module slowly along the guide rails into the slot.
The slot is foolproof. If you cannot insert the power module into the slot, re-orient the power
module rather than use excessive force to push it in.
Figure2-52 Installing a power module (LSVM1AC650)