2-9
Figure2-14 Mounting the switch in the tank (2)
Installing/removing power modules
WARNING!
•
To avoid bodily injury and device damage, strictly follow the procedures in
to install and remove a power module.
•
Provide a separate circuit breaker for each power module.
The switch comes with two power module slots each installed with a power module. You can replace
a power module as required.
Figure2-15 Installation procedure
Figure2-16 Removal procedure
Safety guidelines
To prevent device damage and even bodily injury, follow these restrictions and guidelines when you
install or remove a power module:
•
Always wear an ESD wrist strap and make sure the strap makes good skin contact.
Install the power
module
Connect the power
cord
Switch on the circuit
breaker
Switch off the circuit
breaker
Disconnect the power
cord
Remove the power
module