H3C S5830V2 series, Справочник команд MCE

Страница: 19 / 22

13
The setting configured in IPv4 VPN view takes precedence over that configured in VPN instance view. If
you configure a limit in both IPv4 VPN view and VPN instance view, the IPv4 VPN uses the limit
configured in IPv4 VPN view.
Examples
# Specify that VPN instance vpn1 can still learn new routes after the maximum number of 1000 routes
is reached but generates a syslog.
<Sysname> system-view
[Sysname] ip vpn-instance vpn1
[Sysname-vpn-instance-vpn1] route-distinguisher 100:1
[Sysname-vpn-instance-vpn1] routing-table limit 1000 simply-alert
# Specify that IPv4 VPN instance vpn1 can still learn new routes after the maximum number of 1000
routes is reached but generates a syslog.
<Sysname> system-view
[Sysname] ip vpn-instance vpn2
[Sysname-vpn-instance-vpn2] route-distinguisher 100:2
[Sysname-vpn-instance-vpn2] ipv4-family
[Sysname-vpn-ipv4-vpn2] routing-table limit 1000 simply-alert
vpn-instance-capability simple
Use the vpn-instance-capability simple command to disable routing loop detection for a VPN OSPF
process.
Use the
undo vpn-instance-capability command to restore the default.
Syntax
vpn-instance-capability simple
undo vpn-instance-capability
Default
Routing loop detection is enabled for a VPN OSPF process.
Views
VPN OSPF process view
Predefined user roles
network-admin
Examples
# Disable routing loop detecton for the OSPF process 100 in the VPN vpna .
<Sysname> system-view
[Sysname] ospf 100 vpn-instance vpna
[Sysname-ospf-100] vpn-instance-capability simple
vpn-target
Use the vpn-target command to configure route targets for a VPN instance.
Use the undo vpn-target command to remove the specified or all route targets of a VPN instance.