48
Figure 10
Setting the state of a member port in a dynamic aggregation group
Meanwhile, the system with the higher system ID is aware of the aggregation state changes on the remote
system. The system sets the aggregation state of local member ports the same as their peer ports.
When you aggregate interfaces in dynamic mode, follow these guidelines:
•
A dynamic link aggregation group preferably sets full-duplex ports as the Selected ports. The group
will set only one half-duplex port as a Selected port when either of the following conditions exist:
{
None of the full-duplex ports can be chosen as Selected ports.
{
Only half-duplex ports exist in the group.
•
To ensure stable aggregation and service continuity, do not change the operational key or attribute
configurations on any member port.
•
In a dynamic aggregation group, when the aggregation state of a local port changes, the
aggregation state of the peer port also changes.
