1-22
commonly used networking diagram is as shown in
Figure 1-9
: the member devices exchange
LACPDUs through Device.
Figure 1-9
Network diagram for LACP MAD detection
Device
Master
Slave
IRF virtual
device
Internet
Terminal
network
IRF link
Path where data traffic is transmitted
Path where LACP MAD packets are transmitted
Dynamic aggregation group on
Device, used for LACP MAD and
data traffic forwarding.
Dynamic aggregation group on
the IRF virtual device, used for
LACP MAD and data traffic
forwarding.
Configuring LACP MAD detection
Configure LACP MAD detection in the following order:
z
Create an aggregate interface (also required on the intermediate device);
z
Configure the aggregation group to work in dynamic aggregation mode; (also required on the
intermediate device)
z
Enable LACP MAD detection on the dynamic aggregate interface; (also required on the
intermediate device)
z
Add member ports to the aggregation group.(also required on the intermediate device)
Follow these steps to configure LACP MAD detection:
To do…
Use the command…
Remarks
Enter system view
system-view
—
Enter Layer 2 aggregate interface
view
interface bridge-aggregation
interface-number
—
Configure the aggregation group
to work in dynamic aggregation
mode
link-aggregation mode dynamic
Required
By default, the aggregation
group works in static aggregation
mode.
