H3C s5800 series, Руководство по настройке высокой доступности

Страница: 43 / 233

31
Figure 8 Network diagram for CFD configuration
Configuration procedure
1.
Configure a VLAN and assign ports to it
On each device shown in
Figure
8 , create VLAN 100 and assign ports GigabitEthernet 1/0/1 through
GigabitEthernet 1/0/4 to VLAN 100.
2.
Enable CFD
# Enable CFD on Device A.
<DeviceA> system-view
[DeviceA] cfd enable
Enable CFD on Device B through Device E using the same method.
3.
Configure service instances
# Create MD_A (level 5) on Device A, create MA_A, which serves VLAN 100, in MD_A, and create
service instance 1 for MD_A and MA_A.
[DeviceA] cfd md MD_A level 5
[DeviceA] cfd ma MA_A md MD_A vlan 100
[DeviceA] cfd service-instance 1 md MD_A ma MA_A
Configure Device E as you configure Device A.
# Create MD_A (level 5) on Device B, create MA_A, which serves VLAN 100, in MD_A, and then create
service instance 1 for MD_A and MA_A; in addition, create MD_B (level 3), create MA_B, which serves
VLAN 100, in MD_B, and then create service instance 2 for MD_B and MA_B.
[DeviceB] cfd md MD_A level 5
[DeviceB] cfd ma MA_A md MD_A vlan 100
[DeviceB] cfd service-instance 1 md MD_A ma MA_A
[DeviceB] cfd md MD_B level 3
[DeviceB] cfd ma MA_B md MD_B vlan 100
[DeviceB] cfd service-instance 2 md MD_B ma MA_B
Configure Device D as you configure Device B.
# Create MD_B (level 3) on Device C, create MA_B, which serves VLAN 100, in MD_B, and then create
service instance 2 for MD_B and MA_B;