2-24
Figure2-25 Installing an expansion module with an ejector lever (LSWM4SP8PM)
5.
(Optional.) If the expansion module does not have an ejector lever, perform the following steps
to install it:
a.
Gently push the expansion module into the slot along the guide rails until the expansion
module has good contact with the chassis. See callout 1 in
b.
Use a Phillips screwdriver to fasten the captive screw on the expansion module to secure
the module in the slot. See callout 2 in
Figure2-26 Installing an expansion module without an ejector lever (LSPM6FWD)
2
1
3
4
2
1
