18
Figure 20
Installation procedure
Figure 21
Removal procedure
Installing/removing LSVM1AC300 and LSVM1DC300 power
modules
The installation and removal procedures are the same for the LSVM1AC300 and LSVM1DC300 power
modules. The following procedure uses the LSVM1AC300 power module as an example.
Installing a power module
1.
Wear an ESD wrist strap and make sure it makes good skin contact and is reliably grounded.
2.
Unpack the power module and verify that the power module model is correct.
Keep the packaging box and packaging bag of the power module for future use.
3.
Remove the filler panel, if any, from the target power module slot.
The power module slot filler panel varies by switch model. Follow
to
remove the filler panel.
Figure 22
Removing the filler panel (1)
