H3C S5500-SI Series, Руководство по эксплуатации

Страница: 648 / 1217

1-13
z
Type the device name Switch .
z
Type the IP address of the interface on the switch for connecting the user.
z
Type the key, which must be the same as that configured on the switch.
z
Set whether to enable IP address reallocation. Direction portal authentication is used in this
example, and therefore select No from the Reallocate IP drop-down list.
Figure 1-7 Add a portal device
# Associate the portal device with the IP address group.
As shown in Figure 1-8 , in the device list on the portal device configuration page, click the icon in the
Port Group Information Management column of device Switch to enter the port group configuration
page.
Figure 1-8 Device list
On the port group configuration page, click Add to enter the page for adding a port group, as shown in
Figure 1-9 . Perform the following configurations:
z
Type the port group name.
z
Select the configured IP address group. Note that the IP address used by the user to access the
network must be within this IP address group.