H3C S5500-HI Switch Series, Руководство по базовой конфигурации

Страница: 132 / 180

121
NOTE:
Currently, the memory patch area supports up to 200 patches.
DEACTIVE state
Patches in DEACTIVE state have been loaded to the memory patch area but have not yet run in the system.
Suppose that there are seven patches in the patch file to be loaded. After the seven patches successfully
pass the version check and CRC check, they are loaded to the memory patch area and are in DEACTIVE
state. At this time, the patch states in the system are as shown in Figure 44 .
Figure 44 A patch file is loaded to the memory patch area
ACTIVE state
Patches in ACTIVE state have run temporarily in the system and become DEACTIVE after system reboot.
For the seven patches in Figure 44 , if you activate the first five patches, their states change from
DEACTIVE to ACTIVE. The patch states in the system are as shown in Figure 45 .
The patches that are in ACTIVE state are in DEACTIVE state after system reboot.
Figure 45 Patches are activated
RUNNING state
After you confirm the ACTIVE patches are running, the state of the patches changes to RUNNING and
the patches are in RUNNING state after system reboot. If you confirm the first three patches are running,
for the five patches in Figure 45 , their states change from ACTIVE to RUNNING. The patch states of the
system are shown in Figure 46 .