2-15
Mounting the switch on a wall
CAUTION:
•
Before drilling holes in a wall, make sure no electrical lines exist in the wall.
•
Leave a minimum clearance of 10 mm (0.39 in) around the chassis for heat dissipation.
describes the switch models that support wall mounting and installation holes distances
required for wall-mounting the switch.
Table2-3 Installation hole distances for switch models that support wall mounting
Switch model
Hole distance
S5130S-10P-EI
S5130S-12TP-EI
170 mm (6.69 in)
S5130S-20P-EI
176 mm (6.93 in)
S5130S-10P-HPWR-EI
S5130S-12TP-HPWR-EI
S5130S-16S-PWR-EI
S5130S-16S-UPWR-EI-Q
S5130S-10MS-UPWR-EI
102 mm (4.02 in)
S5130S-20P-PWR-EI
116 mm (4.57 in)
20 mm (0.79 in) long screws and screw anchors as shown in
switches for wall-mounting.
Figure2-10 Screw anchor and screw
To mount the switch on a wall:
1.
Mark two installation holes on the wall. Make sure the two holes are on the same horizontal line.
20 mm (0.79 in)
