2-30
Figure2-32 Installation completed
NOTE:
The PSR1110-56A power supply, including its handle, adds 64 mm (2.52 in) to chassis depth.
Removing a power supply
1.
Wear an ESD wrist strap and make sure it makes good skin contact and is reliably grounded.
2.
Disconnect the power cord.
3.
Press the latch towards the handle, and then pull the power supply part way out along the guide
rails.
4.
Grasping the power supply handle with one hand, supporting the bottom with the other, pull the
power supply slowly out of the slot along the guide rails.
5.
Keep the removed power supply in an antistatic bag or the power supply package bag for future
use.
6.
Install the filler panel in the slot to prevent dust and ensure good ventilation if you are no to
install a new power supply in the slot.
Figure2-33 Removing a power supply
