Command Manual – BFD-GR
H3C S3610&S5510 Series Ethernet Switches
Chapter 1 BFD Configuration Commands
1-6
View
System view
Parameters
active
: Uses the active mode. In the active mode, upon being enabled with BFD, an
interface actively transmits a BFD control packet to the remote device.
passive
: Uses the passive mode. In the passive mode, an interface does not actively
transmit a BFD control packet to the remote end; it transmits a BFD control packet only
after receiving a BFD control packet from the remote end.
Description
Use the
bfd session init-mode
command to configure the mode for establishing a
BFD session.
Use the
undo
bfd session init-mode
command to restore the default. By default, BFD
sessions are established in the
active
mode.
Examples
# Configure the session establishment mode as
passive
.
<Sysname> system-view
[Sysname] bfd session init-mode passive
1.1.8 display bfd interface
Syntax
display bfd interface
[
verbose
]
View
Any view
Parameters
verbose
: Displays detailed interface information.
Description
Use the
display bfd interface
command to display information about BFD-enabled
interfaces.
Besides the information displayed by the
display bfd interface
command, the
display
bfd interface verbose
command displays brief session information of the interfaces.
Examples
# Display information about BFD-enabled interfaces.
