Operation Manual – IPv6 Routing
H3C S3610&S5510 Series Ethernet Switches
Chapter 5 IPv6 BGP Configuration
5-3
Task
Remarks
Optional
Configuring IPv6 BGP Soft Reset
Optional
Tuning and Optimizing
IPv6 BGP Networks
Configuring the Maximum Number of
Load-Balanced Routes
Optional
Configuring IPv6 BGP Peer Group
Optional
Configuring IPv6 BGP Community
Optional
Configuring a Large
Scale IPv6 BGP
Network
Configuring an IPv6 BGP Route
Reflector
Optional
5.3 Configuring IPv6 BGP Basic Functions
5.3.1 Prerequisites
Before configuring this task, you need to:
z
Specify IP addresses for interfaces.
z
Enable IPv6.
Note:
You need create a peer group before configuring basic functions for it. For related
Configuring IPv6 BGP Peer Group
5.3.2 Configuring an IPv6 Peer
Follow these steps to configure an IPv6 peer:
To do...
Use the command...
Remarks
Enter system view
system-view
—
Enter BGP view
bgp
as-number
Required
Not enabled by default
Specify a router ID
router-id
router-id
Optional
Required if no IP
addresses configured for
Loopback interface and
other interfaces
Enter IPv6 address family
view
ipv6-family
—