Operation Manual – Login
H3C S3610&S5510 Series Ethernet Switches
Chapter 2 Logging in Through the Console Port
2-10
the PC, to make the configuration consistent with that on the switch. Refer to section
Setting Up the Connection to the Console Port
” for more.
2.5 Console Port Login Configuration with Authentication
Mode Being Password
2.5.1 Configuration Procedure
To do…
Use the command…
Remarks
Enter system view
system-view
—
Enter AUX user
interface view
user-interface aux
0
—
Configure to
authenticate users
using the local
password
authentication-mode
password
Required
By default, users logging in
through the Console port are not
authenticated, while users logging
in through the Modem or Telnet
need to pass the password
authentication.
Set the local
password
set authentication
password
{
cipher
|
simple
}
password
Required
Set the
baud rate
speed
speed-value
Optional
The default baud rate of an AUX
port (also the Console port) is
9,600 bps.
Set the
check
mode
parity
{
even
|
mark
|
non
e |
odd
|
space
}
Optional
By default, the check mode of a
Console port is set to
none
, that
is, no check bit.
Set the
stop bits
stopbits
{
1
|
1.5
|
2
}
Optional
The default stop bits of a Console
port is 1.
Configur
e the
Console
port
Set the
data bits
databits
{
5
|
6
|
7
|
8
}
Optional
The default data bits of a Console
port is 8.
Configure the
command level
available to users
logging into the user
interface
user privilege level
level
Optional
By default, commands of level 3
are available to users logging into
the AUX user interface.
Define a shortcut key
for starting terminal
sessions
activation-key
character
Optional
By default, pressing Enter key
starts the terminal session.
