Operation Manual – MCE
H3C S3610&S5510 Series Ethernet Switches
Chapter 2 MCE Configuration
2-6
Table 2-9
Configure to use OSPF between a MCE and a site
Operation
Command
Description
Enter system view
system-view
—
Enable OSPF for a
VPN instance (this
operation also
leads you to OSPF
view)
ospf
[
process-id
|
router-id router-id
|
vpn-instance
vpn-instance-name
] *
Required
This operation is performed on the
MCE device. As for the
corresponding configuration on the
site, you can just enable OSPF as
usual.
Enable
multi-VPN-instance
CE for the OSPF
process
vpn-instance-capabi
lity simple
Required
Disabled by default
Configure the
OSPF domain ID
domain-id
domain-id
[
secondary
]
Optional
By default, the OSPF domain ID is 0.
This operation is performed on the
MCE device. As for the
corresponding configuration on the
site, you can just enable OSPF as
usual.
Note:
z
Router IDs of the public network configured in system view do not applies to OSPF
processes bound to VPN instances. So you need to configure the Router ID after
enabling OSPF for a VPN instance.
z
To make sure routes can be advertised properly, you need to configure the same
domain ID for all the OSPF processes bound to a VPN.
z
After enabling OSPF for a VPN instance, you need also to configure to use OSPF
for routing information exchange, which is described in the
IPv4 Routing
module of
this manual.
2.2.5 Configuring to Use IS-IS between a MCE and a Site
An IS-IS process can be bound to only one VPN instance. IS-IS processes not bound to
any VPN instances belong to the public network.
