24
<Sysname> system-view
[Sysname] mad restore
This command will restore the device from multi-active conflict state. Continue? [Y/N]:Y
Restoring from multi-active conflict state, please wait...
port group interface
Syntax
port group interface
interface-type
interface-number
undo port group interface
interface-name
View
IRF port view
Default level
3: Manage level
Parameters
interface-type interface-number
: Specifies a physical port by its type and number.
interface-name
: Specifies a physical port in the
interface-typeinterface-number
format. No space is
allowed between the
interface-type
and
interface-number
arguments.
Description
Use
port group interface
to bind a physical port to an IRF port.
Use
undo
port group interface
to remove the binding of a physical port and an IRF port.
By default, no physical ports are bound to any IRF port.
Before binding a physical port to an IRF port or removing their binding, use the
shutdown
command to
shut down the physical port.
The switch supports up to two physical ports for an IRF port and has the binding restrictions in
.
Table 8
IRF port binding restrictions
Switch model
IRF port binding restrictions
S3600V2-52TP-SI
S3600V2-52TP-EI
S3600V2-52TP-PWR-SI
S3600V2-52TP-PWR-EI
Bind ports GigabitEthernet 1/0/49 and GigabitEthernet 1/0/50 to one
IRF port, and ports GigabitEthernet 1/0/51 and GigabitEthernet1/0/52
to the other IRF port.
Other S3600V2 switch models
No restriction.
Make sure the physical ports at both ends of an IRF link are using the same operating mode. For an
aggregate IRF link, H3C recommends configuring the same operating mode for all physical IRF ports at
both ends.
