H3C S12508CR, Установка, Быстрый старт

Страница: 23 / 30

20
Figure 3-15 Installing a power supply
Connecting power cords
WARNING!
•
Before you connect a power cord, turn off the circuit breaker at the power input end of the power
cord and the power switch on the device.
•
Make sure each power cord has a separate circuit breaker.
Before connecting a power cord, remove the protective plate over the power input area. See Figure
3-16.
Figure 3-16 Removing the protective plate
Connecting an AC power cord
1. Connect the AC power cord connector to the AC input receptacle on the power tray, as shown
by callout 1 in
Figure 3-17 .
2. Attach a cable clamp to the power tray. Release the tab on the tie mount and then slide the
cable clamp forward until it is flush against the edge of the connector, as shown by callout 2 in
Figure 3-17 .
3. Close the cable clamp, as shown by callout 3 in Figure 3-17 .