H3C S12502X-AF, Быстрый старт

Страница: 14 / 29

11
Installing an LPU
The LPU edges and the ejector lever seats on the LPU slots have purple marks.
To install an LPU:
1. Orient the LPU with the upside up based on the orientation of characters on the LPU.
2. As shown by callout 1 in Figure 10 , hold the LPU by the front panel with one hand and support
its bottom with the other. Slide the LPU steadily into the target slot along the guide rails.
Keep the LPU parallel to the slot to avoid touching other components in the chassis.
3. As shown by callout 2 in Figure 10 , pull the ejector levers outward to the outmost when most of
the LPU is inserted into the slot.
4. Push the LPU until the brakes on its ejector levers touch the slot edges tightly.
5. As shown by callout 3 in Figure 10 , continue to push the LPU by its middle part on the front
panel until you cannot move it.
6. As shown by callout 4 in Figure 10 , push the ejector levers inward until they come in close
contact with the panel.
7. As shown by callout 5 in Figure 10 , fasten the captive screws to secure the LPU to the slot.
Figure 10 Installing an LPU
(1) Push the LPU slowly along the guide rails into the slot (2) Pull the ejector levers outward
(3) Push the LPU by the middle part on the front panel (4) Push the ejector levers inward
(5) Fasten the captive screws on the LPU