H3C MSR 50 Series Router
Telecommunications & Certifications Manual
8
Canada – Industry Canada Compliance
CS-03 Compliance
The products listed below meet the applicable Industry Canada technical specifications.
Smart Interface Cards (SICs)
SIC-1ADSL
1-port ADSL2+ SIC
RT-SIC-1ADSL
SIC-1FT1
1-port Fractional T1 SIC
RT-SIC-1FT1
SIC-1AM
1-port Analog Modem SIC
RT-SIC-1AM
SIC-2FXS
2-port FXS SIC
RT-SIC-2FXS
SIC-2FXO
2-port FXO SIC
RT-SIC-2FXO
SIC-1VT1
1-port Voice T1 SIC
RT-SIC-1VT1
SIC-1BU
1-port ISDN-U SIC
RT-SIC-1BU
Flexible Interface Cards (FICs)
1VT1
1-port Voice T1 FIC
RT-FIC-1VT1
2VT1
2-port Voice T1 FIC
RT-FIC-2VT1
4FXS
4-port FXS FIC
RT-FIC-4FXS
4FXO
4-port FXO FIC
RT-FIC-4FXO
4E&M
4-port E&M FIC
RT-FIC-4EM
4T1
4-port FT1/CT1 PRI FIC
RT-FIC-4T1
4T1-F
4-port Fractional T1 FIC
RT-FIC-4T1-F
IMA-4T1
4-port T1 IMA FIC
RT-FIC-4T1
NOTICE: The Industry Canada (IC) label identifies certified equipment. This certification means
that the equipment meets the telecommunications network protective, operational, and safety
requirements as prescribed in the appropriate Terminal Equipment Technical Requirements
document(s). The department does not guarantee the equipment will work to the user's
satisfaction.
Before installing this equipment, users should ensure that it is permissible to be connected to the
facilities of the local telecommunications company. The equipment must also be installed using
an acceptable method of connection. The user should be aware that compliance with the above
conditions might not prevent degradation of service in some situations.
Repairs to certified equipment should be coordinated by a representative designated by the
supplier. Any repairs or alterations made by the user to this equipment, or equipment
malfunctions, may give the telecommunications company cause to request the user to disconnect
the equipment.
This equipment does not contain any parts that can be repaired by the user.
Users should ensure for their own protection that the electrical ground connections of the power
utility, telephone lines, and internal metallic water pipe system, if present, are connected together.
This precaution may be particularly important in rural areas. Caution: Users should not attempt to
make such connections themselves, but should contact the appropriate electrical inspection
authority or electrician, as appropriate.
The Ringer Equivalence Number (REN) is an indication of the maximum number of devices
allowed to be connected to a telephone interface. The termination on an interface may consist of
any combination of devices subject only to the requirement that the sum of the RENs of all the
devices does not exceed five.