H3C MSR 20/30/50 Series Routers User Manual
Chapter 5 Software Maintenance
Select program file please.
Waiting...CC
Select application program file and send it. Upgrading application program with serial
port takes the similar steps with upgrading BootROM. Refer to section
5.3.2
“
Upgrading BootROM
” for details.
Note:
Application program often takes over 10M.Even if the baud rate is changed to 115200
bps, the upgrading takes about 30 minutes. Therefore, it is recommended you upgrade
through Ethernet interface.
5.5 Upgrading Application Program Through Ethernet
Interface
Enter <3> under the main BootROM menu to enter the Ethernet interface submenu.
Refer to section
5.2.2 II.
“
Enter Ethernet interface submenu
” for details.
5.5.1 Configuring Ethernet Parameters
Before upgrading application program through Ethernet interface, we need to configure
the Ethernet interface of the router, as follows:
Enter <3> under the main BootROM menu to enter the Ethernet Interface submenu.
Then, enter <5> to enter the Configure Ethernet interface menu:
Note: Two protocols for download, tftp & ftp.
You can modify the flags following the menu except the boot device.
tftp--0x80, ftp--0x0.
'.' = clear field; '-' = go to previous field; Ctrl+D = quit
boot device : mottsec0 Boot device name. Cannot be changed.
processor number : 0 Processor number. Keep unchanged.
host name : host Host name. Keep unchanged.
file name : main.bin The download file name shall be
consistent with the real file name, and you are asked to designate download
path. Or you can designate download path in FTP and TFTP settings.
inet on ethernet (e) : 192.168.80.10 Set to be in the same network
with TFTP/FTP server. It has nothing to do with port IP address of the router.
inet on backplane (b): No need to set.
host inet (h) : 192.168.80.200 IP address of FTP/TFTP server.
gateway inet (g) : Gateway IP address. No need to
set.
5-14