Manual version: 6PW103-20141219
BOM: 3123A13N
iv
LED Status
Description
GE/Combo copper port
(LINK/ACT)
Off
No link is present on the port.
Steady green
A link is present on the port.
Flashing yellow
The port is sending or receiving data.
5
Installing and removing the card
CAUTION:
•
Wear a well-grounded ESD wrist strap or ESD gloves before you install or remove the card.
•
Do not touch the components on the PCB.
5.1
Installing the card
1.
Locate the slot where you will install the LSQ1LBSC0, and remove the blank panel from the position.
This manual describes installing the LSQ1LBSC0 to slot 2.
2.
Push the module with the components facing upward into the slot along the guide rails until the
positioning hole of the module is seated onto the positioning pin on the backplane. Push the ejector
levers inward to lock the module in place.
3.
Fasten the captive screws on the module with a Philips screwdriver.
