6
LED status
Description
Off
No transceiver module is installed in the
port, or no link is present on the port.
Table 8
10/100/1000Base-T interface LED description
LED status
Description
Steady green
The port is operating at 1000 Mbps, and a link is
present on the port.
Flashing green
The port is sending or receiving data at 1000
Mbps.
Steady yellow
The port is operating at 10/100 Mbps, and a link
is present on the port.
Flashing yellow
The port is sending or receiving data at 10/100
Mbps.
Off
No link is present on the port.
NOTE:
The LEDs are affected by the port mode switching button on your
switch. For more information about the port mode switching button,
see the installation guide for the switch.
Installing and removing the card
CAUTION:
•
Before you install or remove the card, wear an ESD wrist strap and
make sure the wrist strap makes good skin contact and is reliably
grounded.
•
To avoid device damage, do not use excessive force when you
install or remove the card.
The following procedures describe how to install and remove an
LSPM6G4T6P interface card on an S5560-30C-EI switch.
Prepare the following tools before you install or remove the card:
