H3C H3C S7500E-X, Примеры настроек

Страница: 13 / 16

11
#
irf-port 1/1
port group interface Ten-GigabitEthernet1/1/0/1 mode enhanced
#
irf-port 2/2
port group interface Ten-GigabitEthernet2/1/0/1 mode enhanced
#
interface Bridge-Aggregation1
link-aggregation mode dynamic
link-aggregation load-sharing mode source-ip
#
interface Ten-GigabitEthernet1/1/0/9
port link-mode bridge
port link-aggregation group 1
#
interface Ten-GigabitEthernet1/1/0/10
port link-mode bridge
port link-aggregation group 1
#
interface Ten-GigabitEthernet2/1/0/9
port link-mode bridge
port link-aggregation group 1
#
interface Ten-GigabitEthernet2/1/0/10
port link-mode bridge
port link-aggregation group 1
#
• Device C:
The configuration file on Device C is similar as the configuration file on Device A.
Example: Configuring Layer 3 link aggregation
Network requirements
On the network as shown in Figure 3 , perform the following tasks:
• Configure a Layer 3 dynamic aggregation group on both Device A and Device B.
•
Configure IP addresses and subnet masks for the corresponding Layer 3 aggregate interfaces.
Figure 3 Network diagram