H3C FAN-40-5-A Fan Tray User Guide-5PW101
BOM: 3101A0R1
Overview
The FAN-40-5-A fan tray contains five fans. It blows air from the fan tray side to the
power module side. It is hot swappable, and provides low power consumption, fast heat
dissipation and automatic speed adjustment.
Installing or removing a fan tray
Installing a fan tray
Specifications
Views
1.
Hold the fan tray handle with one
hand, support the fan tray bottom
with the other, and align the fan
tray with the fan tray slot. Slide the
fan tray along the guide rails into
the slot until the fan tray seats in
the slot and has a firm contact with
the connectors on the backplane.
2. Fasten the captive screw on the
fan tray with a Phillips screwdriver
to secure the fan tray.
•
Before you install or remove a fan tray, wear an ESD wrist strap and make
sure the wrist strap has good skin contact and is reliably grounded.
•
Do not touch any naked wire or terminal.
•
Do not place the fan tray in a damp environment and prevent liquid from flowing into
the fan tray.
•
When an internal circuit or component is faulty, do not remove any components from
the fan tray. Contact H3C Support.
•
Before you install a fan tray, make sure the fan tray model is compatible with the
device and the airflow direction is as required by the installation site.
•
To avoid damaging the fan tray and the backplane connector, insert the fan tray slowly.
If you encounter a resistance or the fan tray tilts, remove the fan tray and reinsert it.
Removing a fan tray
•
To avoid device reboot caused by over-temperature, finish replacing a fan tray within
30 seconds.
•
Ensure electricity safety when you remove a fan tray on an operating device.
•
Never touch a rotating fan on an operating device.
•
To prevent an unbalanced fan from causing loud noise, do not touch the fan, even if
it is not rotating.
•
Place the removed fan tray in an anti-static mat or bag.
Handle
ESD jack
Captive screw
Fan status LED
Item
Fans
Airflow direction
Max fan speed
Max wind volume
Max power consumption
Voltage
Operating temperature
Operating humidity
Storage temperature
Storage humidity
Five 40 × 40 × 28 mm (1.57 × 1.57 × 1.10 in) fans
From the fan tray side to the power module side
22000 R.P.M
110 CFM
50 W
7.0 V to 13.8 V
–
20
°
C
to +55
°
C (
–
4
°
F to +131
°
F), long-term
55
°
C to 60
°
C (131
°
F to 140
°
F), short-term
5% RH to 95% RH, non-condensing
–
40
°
C to +70
°
C (
–
40
°
F to +158
°
F)
0% RH to 100% RH, non-condensing
Specification
Alarm LED for the fan trays
Status
Steady green
Steady red
Off
The fan tray is operating correctly.
A problem has occurred on the fan tray.
The fan tray does not have power input.
Description
1.
Loosen the captive screw on the
fan tray with a Phillips screwdriver.
2. Hold the fan tray handle with one
hand and pull the fan tray part
way out of the slot. Supporting
the fan tray bottom with the
other hand, gently pull the fan
tray along the guide rails out of
the slot.
2
1
1
2
Copyright
©
2019, New H3C Technologies Co., Ltd.
The information in this document is subject to change without notice.
