H3C ANT-5029D-M2, Руководство по установке

Страница: 6 / 7

Manual Version:5PW100-20120627
5
Mounting the antenna on a mast
To mount the antenna on a mast:
1.
Use four 4 mm (0.16 in) diameter nuts, and corresponding flat washers and spring washers to
attach the feeder to the mounting holes on the reflector. See
Figure 4 .
2.
Use three 10 mm (0.39 in) diameter nuts and corresponding flat washers and spring washers to
mount the reflector mounting bracket and adjustment bolt to the mounting holes at the rear of the
reflector.
3.
Attach the assistant clamp to the mast.
Bolts and nuts are available on the assistant clamp.
4.
Mount the reflector mounting bracket to the mast, making sure the bracket sits on the support
bracket.
5.
Check that the polarization sign on the reflector is point to the right direction.
6.
Rotate the antenna around the mast and adjust the adjustment clamp to obtain the maximum signal
strength.
7.
Fasten all screws.
8.
Connect the antenna connector to the antenna cable.
9.
Weatherproof the connector with sealant tape.
Figure 4 Mounting the antenna to a mast
(1) M16 adjustment bolt (2) Reflector mounting bracket (3) Adjustment clamp
(4) Connector (5) Feeder locking screws (6) Reflector
(7) Feeder