H3 System H3G-980, Инструкция по эксплуатации, Страница: 9 / 15

A. Admin UI Pairing mode
B. Network Pairing mode
2) Admin UI Pairing mode
A. General process
i. Turn on the LTE tele-health modem.
ii. When LTE tele-health modem turns on, LTE tele-health modem shows the
number of currently paired devices with LEDs for 5 seconds.
(Even at the
mode “N”)
Number of paired devices SENDING LED READING LED
0 Off Red On
1 Green On Off
2 Green On Green On
3 Green On Red On
4 Red On Off
5 Red On Green On
iii. AdminUI Setting CheckBox check
iv. CDMA, Bluetooth Log listbox log scroll will stop and pairing standby
v. Let the device be at pairing mode.
vi. In the Pairing Device List listview, Select record and click Pairing button
vii. Pairing will start
viii. During pairing process, the “Readings” LED turns GREEN.
ix. At successful pairing, the “Readings” LED blinks GREEN 5 times.
x. At successful Admin UI Info Device List listbox will add pair info.
xi. At failure, the “Readings” LED blinks RED 5 times.
xii. The LTE tele-health modem goes to the step “v.”
xiii. You can pair another device at the same pairing mode successively.
xiv. After completion of pairing, UnCheck AdminUI Setting CheckBox, LTE
tele-health modem will normal operation.
xv. For failure, just let the device at pairing mode and find the result. (Step
“vii” and “viii”) Don’t turn off the LTE tele-health modem and restart the
whole procedure again.
3) Network Pairing mode
A. Prepare
1. AMC or patient requests BT device pairing with target GW and BT device
information.
(H3G-980(GW), target Bluetooth(BT) device).
2. AMC confirms the corresponding information and registers the information
into AMC
’
s DB.
(btaddress. Serial, Pincode, devtype)
3. AMC can register several BT device.
B. Pairing
1. AMC turns on the pairing start flag of the relevant DB record.
2. GW Network Pairing(NP) process.
- AMC asks the patient to restart the patient
’
s GW.
- Patient checks the GW's standby mode by looking at the LED light.