A.
Admin UI Pairing mode
B.
Network Pairing mode
2)
Admin UI Pairing mode
A.
General process
i.
Turn on the 3G tele-health modem.
ii.
When 3G tele-health modem turns on,3G tele-health modem shows the number
of currently paired devices with LEDs for 5 seconds.
(Even at the mode “N”)
Number of paired devices
SENDING LED
READING LED
0
Off
Red On
1
Green On
Off
2
Green On
Green On
3
Green On
Red On
4
Red On
Off
5
Red On
Green On
iii.
AdminUI Setting CheckBox check
iv.
CDMA, Bluetooth Log listbox log scroll will stop and pairing standby
v.
Let the device be at pairing mode.
vi.
In the Pairing Device List listview, Select record and click Pairing button
vii.
Pairing will start
viii.
During pairing process, the “Readings” LED turns GREEN.
ix.
At successful pairing, the “Readings” LED blinks GREEN 5 times.
x.
At successful Admin UI Info Device List listbox will add pair info.
xi.
At failure, the “Readings” LED blinks RED 5 times.
xii.
The 3G tele-health modem goes to the step “v.”
xiii.
You can pair another device at the same pairing mode successively.
xiv.
After completion of pairing, UnCheck AdminUI Setting CheckBox, 3G
tele-health modem will normal operation.
xv.
For failure, just let the device at pairing mode and find the result. (Step
“vii” and “viii”) Don’t turn off the 3G tele-health modem and restart the
whole procedure again.
3)
Network Pairing mode
A.
Prepare
1.
AMC or patient requests BT device pairing with target GW and BT device
information.
(H3G-850(GW), target Bluetooth (BT) device).
2.
AMC confirms the corresponding information and registers the information
into AMC’s DB.
(btaddress. Serial, Pincode, devtype)
3.
AMC can register several BT device.
B.
Pairing
1.
AMC turns on the pairing start flag of the relevant DB record.
2.
GW Network Pairing(NP) process.
- AMC asks the patient to restart the patient’s GW.
- Patient checks the GW's standby mode by looking at the LED light.
- AMC instructs the patient to make the BT device be at pairing mode.
3.
GW's LED indicates the pairing status.
