The Activated Carbon Pod helps to reduce any
noticeable taste or residual gases. Replace the
Activated Carbon Pod every 30 to 60 days, or
whenever there is any noticeable taste or odor.
To replace the Pod
, press the middle tabs on
each side of the nozzle and TILT it out of the
slots. (See illustration.)
Use force if necessary.
It may be helpful to use small flat head screwdriver to push the Nozzle
tabs in to release them from the slots. If using a screwdriver, be careful
not to enlarge or damage the slots.
TROUBLE SHOOTING
(Visit www.H2oLabs.co.uk for additional Trouble Shooting Guidance.)
Fan does not come on or unit is not making any water:
-Fan power cord
not plugged firmly
into the bottom socket of the unit.
Use extra force to push the fan cord plug into the fan cord socket.
-Main power cord not plugged firmly into the household outlet or unit.
-No power to the household electrical outlet. Check outlet.
-Power/Reset button not pressed.
Not making a full 4 Litres of water:
-Water was not filled to the mark inside boiling chamber.
-Steam or water leaking. See below.
Steam or water leaking:
-Fan power cord
not plugged firmly
into the bottom of the unit.
-Head Assembly, (top of the unit), not seated securely on the Main
Body, (bottom of the unit).
-Rubber Ring Seal, (attached to bottom of Head Assembly), not seated
properly, (or if removed, reinstalled upside down).
-Carafe and/or Nozzle not positioned properly under the water outlet
spout.
-Activated Carbon Pod not properly positioned in the Nozzle and/or
plugging Nozzle outlet.
Attention Dental Offices: It is not recommended to use activated carbon
pods when making distilled water for autoclave use.
- 11 -
