H·KING
CONTENTS
Box Contents .................................................................................... 01
Specifications ...................................................................... O 1
Assembly ............................................................................. 02
Control Horn and Servo Arm Setting ............................................... 03
Control Direction Test .................................................................. 04
Clevis Insta I lation .................................................................. 0 5
Control Surface Centering ................................................................. 05
Throttle Range Setting .................................................................. 05
CG Location ............................................................................. 06
Accessories ............................................................................... 07-08
Trouble Shooting ..................................................................... 09
Model Flying Precautions ..................................................................... 10
Pre-Fli ght Checks ................................................................ 10
TROUBLE SHOOTING
Problem
Motor does
not turn
Model moves
backwards
Cause
1. Battery is not fully charged
2. Transmitter battery low
3. Motors not connected
4. The motor is damaged
5. Reciever is not bound to Tx
6. ESC in set-up mode
1. Both ESC and motor are not
establishing a proper response
range
H·KING
Solution
1. Charge the batteries
2. Install a full charged battery
3. Check for connection between the
ESC and
4. Replace motor
5. Consult Radio manual and go
through bind procedure again
6. Hold model and movethrottle to full
postion then back down to idle
1. Locate the three (3) connections between
the motor and ESC, disconne
c
t two (2) of
the three (3) and swap their places for
proper response
Control Surfaces 1. The servo lead may be connected
1.Make sure the servo leads are properly
are not responding to the receiver incorrectly
connected to the receiver
to stick input
2. The servo is damaged
2.Replace the servo
Model is flying
erratically
Model does not
climb well
Limited Radio
Range
1.The control surfaces are not centered
2.The control surfaces are severely off
center
3.Center of Gravity (CG) is not in the
correct position.
1.The battery is not fully charged
2.Elevator surface response is
reversed
3.CG is too far back causing a tail
heavy airframe
1. Transmitter or receiver
(if applicable) power is low
-09-
1.Make trim adjustments as necessary
on the transmitter if the issue is not serious
2.Make manual adjustments as necessary
to the surface control linkages
3.Re-position the Li-Po ba
t
tery as necessary
to achieve a balanced CG.
1.Re-charge the battery within the
specified charge time
2.Charge the surface direction via the
'reverse' function on the transmitter
3.Re-position the Li-Po battery as
necessary to achieve a balanced CG
1. Charge or replace any batteries used
on the transmitter and receiver (if
applicable)
