When you are satisfied with the alignment,
use a pencil to trace around the left and
right of the stabilizer where it meets the
fuselage(6B)
6B
TOP VIEW
Cut 7/8” (22mm) long slots along the hinge line in the
trailing edge of the vertical stabilizer for the rudder
torque rod bearing. Position of the slot on the side of
the vertical stabilizer, 2”(50mm) from the bottom (6A)
Test-fit the rudder torque rods into the slot.
NOTE: You may need to open up the slots so that
the torque rod bearing are not too difficult to push in
6A
Do not glue as this time
Full the rudder out of the Vertical stabilizer.
6- Vertical stabilizer
PC-6 Porter
4
