H-KING Hummer, Инструкция по эксплуатации

Страница: 7 / 9

6
17. Use a Xacto knife to make another 4 slots which correspond to the ones on the rudder. Then
insert those paper hinges to the rudder post and apply glue to secure it.
18. Install the supplied plastic horn on the elevator as shown.
19. Make a cutout on the fuselage for the elevator servo. The cutout location should be 13cm
away from the fuselage rudder post.
20. (This step applies to all the control surfaces set-up on this plane) When install the pushrod linkage
to the elevator, ensure the servo horn and control surface is level. Install the pushrod adjuster to the
servo horn and also install the pushrod at the same time. Once satisfied with the fit, tightened the
grub screw on the adjustor and trim the excess of the pushrod.
21. Assemble the plywood motor mount and apply glue to all the joints.
17 18 19
20 20 21