H+C DH304025, Руководство по установке

Страница: 3 / 16

Danze, Inc. / 2500 Internationale Parkway / Woodridge, IL 60517
www.hcwaterware.com
INSTALLATION, CARE AND CLEANING
INSTRUCTIONS
FOR YOUR NEW
Two-Handle Lavatory Faucet
2
BEFORE YOU BEGIN: Read this important
information.
1. This product is engineered to meet the EPA
WaterSense flow requirements. The flow rate is
governed by the aerator. If replacement is ever
required, be sure to request a WaterSense compliant
lavatory faucet aerator to retain the water conserving
feature of this product.
2. Shut off main water supply before installation.
3. Check to make sure you have the following parts
indicated below:
1. Spout Assembly
2. Mounting Hardware Assembly
2.1 Rubber Washer
2.2 Metal Washer
2.3 Lock Nut
3. Metal Handle Assembly
4. Mounting Hardware Assembly
5. Valve Body
6. Supply Hose
7. Touch Down Drain
Step 1. Install spout
A. Apply silicone sealant around bottom of spout
trim ring. Insert spout into middle mounting
hole in deck from above.
Important: Orient slot in mounting washer to
rear of spout to allow lift rod for drain to pass
through.
B. NOTE: Two different kinds of specification for
installing shank
B-1. From underneath the sink, install the washers
and lock nut. Slide on adapter over bottom of
spout shank, and tighten with lock nut.
Tools and Supplies you will
need to complete your
installation
1-A.
1-B.1. 1-B.2
1.
3.
4.
5. 6.
7.
2.
2.1.
2.2.
2.3.
DH304025 Shown
Adjustable
wrench
Pipe tape
Phillips
screwdriver
Groove joint
pliers
Hex wrench
Silicone
sealant
Supply hoses or tubes
with1/2” coupling nuts to
connect faucet to water
supply valve